To prove this you may try replacing the cfl lamps with incandescent or halogen lamps of the specified watt rating.
Woods dusk to dawn light control troubleshooting.
If the photo cell and control circuitry is functioning properly and the light bulbs are good the fixture should light up.
Connect more fiber optic to the sensor.
Resetting dusk to dawn light is quite a simple task.
Automatically turns light on at dusk and off at dawn.
These are some of the ways you can adjust your dusk to dawn sensor depending on what type of sensor it is and how it can be operated.
The main reason dusk to dawn lights don t turn on or stay on is that the sensor is frozen in the on or off position.
Relocate the light sensor behind more plants and such.
First of all turn off the lights using the light switch.
The second step leave it off for about a second.
I got on a ladder and cleaned the dust off the small round light sensor.
Easy installation with screw in design.
We installed it about three years ago and never had problems with it then all of a sudden it began to come on for a short period of time and then it would shut off.
I have a small dusk to dawn light that s acting funny.
Here are a few ideas on how.
Dusk to dawn outdoor flood lights go on and off solvedsupport channel with paypal donation.
Incandescent fluorescent led halogen mercury vapor high pressure sodium or cfl compatible.
White dusk to dawn light control.
Use the circuit diagram to know where to sensitize the sensor.
Troubleshooting dusk to dawn light fixtures with cfl lamps i would suspect that the automatic light controlled sockets that you are describing will not work with cfl lamps.
If the lights are controlled by a timer the timer may become out of sync due to daylight savings or other reasons.
With the power on to the light fixture place a small strip of black electrical tape over the photo cell to block the light.
That s all you need to do to reset your dusk to dawn lights.
Depending on the photo cell it may take about 30 seconds for the photo cell to turn on.