Place a magnet between the two so there is a magnetic connection between the lid lock and the solenoid inside the washer.
Whirlpool washer lid lock test.
If it still won t budge proceed to plan b.
I hope this is helpful.
Repeat door unlocks lid lock indicator turns off.
Let the washer sit unplugged for about 10 minutes then try lifting the lid.
If you have a kenmore or whirlpool made washer and it is not spinning or draining this is going to be the first thing you want to check.
If not replace the lid lock.
Door must be closed.
If the door is not closed an invalid button press beep will occur when performing the next step.
Check the lid lock position and adjust if needed nbsp.
To diagnose this problem you ll want to put the washer in a spin mode.
Next open the lid and insert a screwdriver into the lid switch actuator hole.
The lid lock switch cannot be tested but if it were bad the control will attempt to lock the door and the door will actually lock.
The most common reason for rep.
The next test is the lid lock solenoid.
Rotor position sensor rps test.
Door lid lock test.
Look for the lid lock switch on the underside of the top panel and where it fits into the appliance.
The lid lock mechanisms on some washers are heat activated which means overriding them is as simple as letting them cool off.
Step 4 put the lid back down and plug the washing machine back into the electrical outlet.
I also add an image on how to test the lid lock and an image on how to replace the lid lock if needed.
If the circuit is open replace the lid lock.
Based on your symptom and details the lid lock may need to be adjusted.
Test for ohms between the white and yellow wires.
This video shows y.
This is one of the most common problems with direct drive washing machines.
If it opens you re all set.
If your whirlpool cabrio washer will fill with water but won t spin the lid lock switch is probably bad.
This video provides step by step instructions for replacing the door lock or lid latch assembly on whirlpool washing machines.