Whirlpool Washer Door Latch Bypass

Locate the lid door lock switch on the underside of the panel basically where the lid door fits with the body of the washer.

Whirlpool washer door latch bypass.

If the switch does not have continuity then it must be replaced. Once you re finished with the washing machine be sure to put the screw back into place. I have a question. Repair guides and support for top and front loading whirlpool brand washers.

In order to bypass a door switch on a front loader when diagnosing electrical problems the power must be disconnected and the front panel must be removed. Now place a magnet between door lock and the solenoid that will create a magnetic connection between them. Washing machines must have some way in which you can lock the door closing mechanism when the machine is started up and then unlock them with a certain delay normally two minutes after the current has switched off via the program or on off switch in order to ensure that the door cannot be opened while some of the components are still rotating initially in particular the motor and the drum of the spin dryer. Where to bypass door lock.

Reassemble the washer and try it out. This video provides step by step repair instructions for replacing the door latch on a whirlpool front load washer. It is the only connector that goes into the top of the washer body. Tuck the newly joined wires back into the switch casing reinstall the removable cover and press down on it until it clicks.

Squeeze the locking tab on the harness and pull it out of the connector. My lid lock only had three wires red white and blue. This unlocks the door and allows you to access the washer. Locate the lid switch connector on the top of the washer body under the control panel.

The main control checks the door lock assembly to get information about the state of the lock lock unlocked etc if the main control does not get the proper resistance readings back from the lock the control will not allow the washer to do anything. Tug on the plastic cord in the compartment to unlock the washer door. 275 questions view all. Reposition the switch on the underside of the machine s top panel and tighten the mounting screws then secure the top panel once again.

Is this the same process to bypass mine. Step 4 place the lid door panel properly and fasten the retaining tabs or screws as necessary.